Sentence examples for maximum difference value from inspiring English sources

Because the LL subband has no directional information, we obtain the rounded maximum difference value as follows.

It is shown that the maximum difference value between the proposed offline algorithm and the algorithm under SRT with a priori knowledge about CSI is 4.3% and the maximum difference value between the proposed online algorithm and the algorithm under SRT with limited pre-knowledge about CSI is 5.8%.

For this purpose, we propose that attachment points obtain the difference between available bandwidth on each route and the required bandwidth and select the route with the maximum difference value.

The daily variation makes the values of the real-time sampling sequence deviate from the presurveyed geomagnetic maps (mostly after the process of variation normalization already), with the maximum difference value up to 40 nano-Telsa (nT) indicated in Figure 1.

If we denote the available bandwidth along route j and the bandwidth required by the application by BW j and BWreq, respectively, the attachment point selects the route with the maximum difference value, namely route k, as follows route k = arg max route  j ∈ U B W j - B W req. (1).

Compared with [14], the demand of active power injection using UPQC-S strategy P inj' can be given by P_{text{inj}}^{prime} = V_{text{L}} I_{text{L}} left[ {cos varphi - delta_{hbox{max} } ) + frac{{cos delta_{hbox{max} } }}{D}} right] (15 where δ max is the maximum difference value of phase angle between the pre-compensated and compensated load voltage.

Statistically, the two images are not very different; the maximum difference in value between any two pixels in the two images is 22, and the average gray level difference between the two images is essentially unchanged (0.02) with a standard deviation of 1.56.

The most ordered flower-like molybdenum oxide film which has the best photochromic performance exhibits a maximum color difference value of 8.921 when the volume ratio of formaldehyde solution and sodium molybdate solution is 0.3:10.3

Time could be saved by preselecting the m/z-intervals based on the mean spectra difference, e.g. by taking only coefficients from the intervals with an absolute difference larger than a fraction M (0< M<1) of the maximum absolute difference value.

Sweeps containing artifacts (maximum difference of values within the sweep exceeding 100 μV in any electrode) were discarded, the average rejection rate being approximately 34%.

Before an attack occurs, the measure of interest M has the value m 0; m a is the value of M just after the attack arrives; m u is the maximum difference between the value of M and m a after the attack arrives; m r is the recovery value of M after the time t r ; and t R is the relaxation time for the network to recover the value of m 0. Fig. 1 Illustration of survivability (adapted from [7]).