Sentence examples for maximum density that from inspiring English sources

The maximum density that can be achieved in the liquid state is studied in the 2 N-1) dimensional parameter space of N-component systems.

Particle sizes and their distribution control the compaction characteristics, including maximum compaction density that may be achieved during the disposal, and selection of appropriate compaction equipment.

CA-based models are characterised by a limit to the maximum manageable density that also limits their possibility to effectively represent highly crowded situations.

The cell population ceiling is the maximum cell density that could be sustainably maintained in a RaBIT fermentation system.

Although our protocol is given in detail below, we therefore recommend that researchers obtain their own estimate of the maximum inoculum density that can be used in their conditions; that is conditions which give an outcome which falls below the coalescence threshold.

The maximum power point is fixed in a three-parameter space, and operation at this point leads to maximum power density that scales with the inverse square of the engine dimension.

The addition of salt also lowers the temperature of maximum density below that of pure water (4 °C [39.2 °F]).

According to DIN 4049, Part 2 (1980), the maximum In situ relative density that can be sounded by LRS 10 is 0.5 in soil in which the ground water table is not encountered during exploration, and approximately 0.55 where ground water is encountered.

The total concentration of microparticles was 4% w/v; this was the maximum density of microparticles that could be reliably imaged with optical methods.

In many crops, such as cereals, this decline occurs at much higher densities than the lowest density that gives maximum yield (i.e. the optimum density without weeds).

The intensities at such facilities are principally limited by decay losses associated with times required for diffusion-release from target materials and transport from the target to the ion source and by the maximum permissible primary beam power depositional density that can be tolerated without deleteriously affecting target integrity or ion source efficiency.