Sentence examples for maximum current response from inspiring English sources
Maximum current response was registered when the pH of the buffer solution was 6.0.
In terms of electrical performance, maximum current response of 1.6 A/m was achieved.
Evidently, the glucose oxidation at 0.54 V results in the maximum current response, and thus 0.54 V is set as the working potential in the subsequent investigation.
Maximum current response was obtained for a 1 week old 5 bilayer film immersed in a pH 2.85 0.10 M NaCl (aq) solution containing 1000 μM ClO3−.
In order to estimate the Michaelis-Menten constant and maximum current response, the measured current values are linearized with the help of Hanes-woolf plot.
It is also noticed that the DNA hybridisation time of the fabricated arowana DNA biosensor was temperature dependent, and as a great advantage, we obtained a maximum current response at room temperature within 30 min (Fig. 8).
The GIRK channel current in response to simultaneous MOPr and α2-adrenoceptor activation did not exceed the maximum current in response to MOPr activation alone, indicating that these receptors couple through Gi/Go proteins to the same set of GIRK channels.
If no antidromic response was observed visually, responses were recorded using the maximum current (350 µA), otherwise, responses were recorded at 130% of threshold current.
If no response was present on the maximum current intensity of 1 mA at 0.1 ms, the pulse width was increased to 0.3 ms and then to 1.0 ms, the electrical charge thus varying from 0 to 1000 nC (nC = mA × ms × 1000); if no response was obtained at 1000 nC, the current scale was increased to 5 mA and a motor response was sought up to a maximum electrical charge of 5000 nC.
As shown in Figure 5, with the mass proportion of MWCNTs/carbon paste (MWCNTs: carbon paste) changing from 1 50 to 2 5, the cathodic current response (expressed as the percentage of the maximum response) of DA at the Lac/Si/MWCNTs/SPE enhances, and reaching its maximum at 3 10.
Concentration response data were measured at a holding potential of −60 mV, and responses for each oocyte were normalized to the maximum current for that oocyte.
