Sentence examples for maximum crack widths from inspiring English sources
Besides the presentation of the methodology of determining statistical properties of crack widths, it is shown that mean and maximum crack widths might be underestimated by analytical models as recommended in current design codes.
It was found that at maximum crack widths below 0.6 mm, the majority of beams exhibited nearly similar crack patterns as well as rate of widening of corrosion cracks.
Also, the maximum crack widths for the constant current specimens were greater than those of the constant voltage specimens.
Average and maximum crack widths and crack spacing in the R/SHCC are smaller for larger cover depth of the steel bar.
Maximum crack widths were reported for the vertical cracks at midspan, at splice ends and under the two concentrated applied loads.
In addition, the maximum crack width and the ultimate bearing capacity were measured.
The serviceability criteria for design of GFRP reinforced beams appear to be governed by maximum crack width.
A mass loss of steel of 1% corresponded to a maximum crack width between 0.14 and 0.22 mm.
In general, it is assumed that the deterioration increases with increasing crack width and, thus, maximum crack width might be most critical.
The test results also indicate that the maximum crack width at a certain drop stage decreased with the reinforcement ratio.
