Sentence examples for maximum carrier from inspiring English sources

The cell with minimum internal resistance and maximum carrier life time had maximum power conversion efficiency.

No significant toxicity was observed even at a 250X dose of the maximum carrier mass [19F]FTC-146 expectod to be injected for human studies.

To understand the dependency from the frequency offset value, we report in Figures 8 and 9 the BER as a function of the maximum carrier frequency offset.

Given the increase in gate widths from 100 nm to 4000 nm, the maximum carrier mobility of 116.57% and 111.01% were obtained when isotropic and anisotropic material properties were adopted.

Let Fmin and Fmax be the minimum and maximum carrier frequencies: the out-of-band carriers F1 and F2 are defined as F1 = 0.95 · F min and F2 = 1.05 · F max.

These schemes are derived from the maximum signal-to-noise ratio (MaxSNR), also known as maximum carrier to interference ratio (MaxC/I), technique which allocates the resource at a given time to the active mobile with the greatest SNR.

Maximum carrier-mediated transport efficiencies were obtained at following conditions: pH 1.9 for feed aqueous solution; 0.014 mol L− 1 of ligand in toluene as carrier and 2.9 mol L− 1 HNO3 in the stripping solution.

Well-known packet scheduler algorithms, i.e., round robin (RR), proportional fair (PF [14], and maximum carrier-to-interference ratio (MAX C/I)[15], are included in the simulator to evaluate performance under different types of packet schedulers.

Through computer simulation, the performance of the proposed EES packet-scheduling algorithm using mixed traffic is compared with the State-of-the-Art (SoTA) packet-scheduling algorithms such as Maximum Carrier-to-Interface ratio (MCI), Proportional Fairness (PF), and Round Robin (RR), which eventually shows the significant improvement.

With TDPPT and FDPPT, maximum hole carrier mobility obtained is 2.88 × 10−3 cm2 V−1 s−1 and 1.60 × 10−3 cm2 V−1 s−1, respectively using bottom gate bottom contact field-effect transistor.

The conventional maximum likelihood carrier recovery approaches[26 28], as shown in Figure 4, requires implementing a pair of band-edge (BE) filters that operate in parallel with the SRRC filter.