Sentence examples for maximum bed temperature from inspiring English sources

Figure 2 Location of the maximum bed temperature and bed surface in relation to the average temperature of the bed.

The proposed bioreactor system with intermittent mixing gave superior performance than PBR and tray bioreactor, in terms of maximum bed temperature, axial bed temperature and biomass gradient, average bed moisture content, biomass and phytase productivity.

Parametric studies are performed to investigate the effects of gas inlet temperature and rate of charging on the maximum bed temperature and the time required to fill the cylinder.

Estimates are derived for the maximum bed temperature in a reverse-flow reactor in which two reactions, having relatively low adiabatic temperature rise, occur and are masstransfer limited at the high temperature zone in the bed.

The Pd/CZO catalyst provided the best combination of NO storage with C2H4 and H2O above 100 °C, essentially complete NOx release at the maximum bed temperature of the US06 simulation (400 °C), low NO2 and N2O formation, and cost effectiveness.

A higher air inlet temperature resulted in lower maximum bed temperatures, which was successfully modelled.

The beryllium thermal conductivity is determining the maximum pebble bed temperature and, therefore, is very important for blanket design.

Results showed that the MCR increases by reducing the aperture width, meanwhile the maximum catalyst bed temperature (MCBT) can be reduced by 17.9 °C.

The maximum debris bed temperature attained during the initial hours of PAHR does not depend much on when the Decay Heat Exchanger (DHX) gets operational, and it substantiates the inherent safety of the system.

Different influences (bed length, gas velocity of bed, initial bed temperature, feed concentration and cycle time) on maximum gas temperature and average conversion, etc., are obtained.

The average particle temperature exceeded the bed temperature by about 100 200 K, while the maximum particle temperatures were nearly 600 K above the bed temperature.