Sentence examples for maximum bearing capacity from inspiring English sources

The best geometry and orientation of the geogrid layers were determined to achieve maximum bearing capacity for closely spaced square footings.

The variation of conductor lateral displacement with wellhead load and the variation of conductor vertical maximum bearing capacity with conductor size have also been figured out.

A series of equations are proposed to predict the ultimate vertical, moment and maximum horizontal bearing capacity factors.

The maximum load bearing capacity of the annealed interfaces reaches about 304 nN, a 40.1% increase from that of the non-annealed ones (about 217 nN).

This study measured the maximum loading bearing capacity of the wallettes and assessed the possible structural rehabilitation in the damaged masonry structures after the reinforcement with the FRP. Figure 1 Geometric configuration of the wallettes, with the applied compressive loading.

This fact, combined with the maximum loading bearing capacity shown by the CW2 and CW3 specimens (as in Table 5), implies that the application of the putty contributes to the rehabilitation, as well as to the increase of the loading bearing capacity, as the result of a better bonding of the reinforcement system to the substrate.

For a settlement of 15% of foundation width, the maximum improvement in bearing capacity for coir geocell was found to be 7.92 compared to 5.83 in the case of planar forms.

For the optimum value of rubber content of 5% at footing settlement level of 5%, the maximum improvement in bearing capacity of rubber-reinforced bed was obtained as 2.68 times of the unreinforced bed.

Two failure criteria are included to determine the maximum load-bearing capacity and deflection.

The analyses are planned to initially verify the equilibrium results of the 3DGS model and to predict the maximum load-bearing capacity of the structure by studying the failure mechanism of the system.

The interfacial shear strength and the maximum load-bearing capacity of the tested CNT-Ti interfaces are quantified to be about 37.8 MPa and 245 nN, respectively, both of which are substantially higher than the reported values for CNT-Al interfaces.