Sentence examples for maximum axial strain from inspiring English sources

After consolidation undrained monotonic axial load was applied at a strain rate 0.05% per minute till maximum axial strain 15% (ASTM-D4767-02) [35].

In addition, the Jahed Varvani energy model was used for fatigue life prediction and was shown to have a potential to be evaluated at plane of maximum axial strain energy density.

Besides that, from Fig. 11 it can also be seen that the maximum axial stress in the stainless steel used on the EBR with SS specimens and measured by the strain gauges is quite far away from its rupture value.

Dilation of the ascending aorta preferentially occurs at the outer curvature of the vessel, which has the maximum axial stress.

Based on this, modelling equations are proposed to predict maximum axial load, axial strain and lateral strain, as well as the entire behaviour until failure with curves of axial load axial strain and axial load lateral strain.

These results were compared with pure bending test results obtained by a test device that can simulate a pure bending state for maximum 4% axial strain with uniform deformation curvature.

From the testing results on the samples, the maximum axial free swelling strain is about 1.2%, while the maximum axial confined swelling strain is around 0.1% with swelling stress less than 25 kPa.

This stress strain loop is typically obtained from a routine CTX test, where the loop is related to the maximum values of cyclic axial strain and cyclic deviatoric stress.

This chapter proposes an empirical formula, which represents the critical buckling strain in terms of the ratio of the maximum bending strain to the axial strain Cb/Ca, and the wall thickness to radius ratio t/R.

This chapter proposes an empirical formula that represents critical buckling strain in terms of the ratio of the maximum bending strain to the axial strain Cb/Ca, and the wall thickness to radius ratio t/R.

Since a band is assumed to grow during a discrete stress drop and AE pulse (e.g. Baud et al. 2004), we can estimate (assuming uniaxial strain and that the bands are perpendicular to the maximum principal stress) that the inelastic axial strain associated with band growth is typically between 0.04 and 0.06%% for both C8 and LAH4 (corresponding to an axial shortening of about 20 μm).