Sentence examples for maximum attenuation of from inspiring English sources

Much earlier, Winterstein (1987) related the quality factor (Q) variations in a multilayered medium to the inhomogeneity (angle between propagation direction and direction of maximum attenuation) of the attenuating waves.

We therefore apply a Wiener filter with a maximum attenuation of 6 dB to the signal.

The isolator is proved efficient in a frequency band between 5 and 400 Hz, with a maximum attenuation of −40dB between 50 and 200 Hz.

The system with M=4 has been configured with Q=2, and the noise reduction applies a maximum attenuation of β=-12 dB.

Attenuation was calculated by the method suggested by Martínez-Martínez et al. ([2011]) utilizing transmission of the ultrasonic wave and maximum attenuation of the waveform plotted versus axial compressional wave velocity (Vp) obtained under an axial stress of 10 MPa.

where ϕ 3dB and θ 3dB represent the horizontal and vertical half-power beamwidth, respectively, A m represents the maximum attenuation of the array antennas, and θ tilt denotes the antenna tilting angle which is allowed to be adjusted within the given interval.

With the objective of obtaining an overall extended noise reduction including a postfilter for residual cross-talk suppression (RCS) and a dynamic maximum attenuation to realize a dynamic combination of the microphone signals later, two approaches are combined to one noise reduction characteristic.

An nMOS-switch with optimized switching performance is used as shunt switch to improve the flatness and maximum attenuation range of the attenuator.

The design shows maximum attenuation range of 21 25 dB, attenuation flatness of <2.4 dB, and insertion loss of 0.6 2.1 dB over DC-20 GHz frequency band.

However in those segments with layering of contrast, the maximum attenuation (HU) of the least tagged layer was significantly higher for regimens C and D than for regimens A and B (P = 0.002) [77 (SD 105), 119 (SD 139), 155 (SD 118) and 174 (SD 122), for regimens A to D respectively].

The attenuator is controlled with a 5-bit digital signal to achieve the maximum attenuation amplitude range of 0 31 dB with 1 dB increase at 3 22 GHz.