Sentence examples for maximum amount of surface from inspiring English sources

The maximum amount of surface relaxation is seen in Au-Fe (100) with a contraction of about 9.37%.

In the process optimization, the maximum amount of surface area was achieved concurrently with the minimum values for particle size at 5.38 m2/g and 190 nm, respectively.

It was remarkably noticed that in submonolayer bimetallic systems, again, the system containing Fe, i.e., Au-Fe-Au (100), has the maximum amount of surface contraction.

The maximum amount of surface NO was found to be independent on the temperature and N2O concentration in the gas phase.

Fill wine glasses no higher than the widest point in the bowl to expose the maximum amount of surface area.

(With drill press) place the dice in the vise or holding device at the bottom of the drill press as far down as you can so that it is held by the maximum amount of surface area possible by the holding device.

Regarding the relationship between the maximum amount of sea surface cooling and the TC, it has been suggested that TC-induced sea surface cooling of more than 2.5°C will not cause the intensification of a TC because this degree of cooling should be sufficient to shut down the entire energy production process of the TC (Emanuel 1999; Emanuel et al. 2004; Lin et al. 2008).

The names and numbers of these eight typhoons, the analysis period for each typhoon, and the maximum amount of sea surface cooling that was observed by the three profiling floats during each analysis period are shown in Table 1.

The analysis period is the period during which the typhoon passed over the area monitored by the profiling floats (Figure 1), and the maximum amount of sea surface cooling, which ranged from 0.8°C to 4.3°C (Table 1), was defined as the difference between the maximum and minimum water temperature at a depth of 5 m during each analysis period.

It was found that 20 min of PEO followed by 4 h of hydrothermal processing at pH = 11 produced a maximum amount of hydroxyapatite in the surface layer.

With increasing the initial pH value of solution from 2 to 8, removal of EtBr by GO surface as adsorbent increased, and maximum amount of adsorption of (EtBr) on (GO) surface was at pH 8.