Sentence examples for maximum acceptable rate from inspiring English sources

The consumer defines the LTPD as the maximum acceptable rate of poor quality.

(5) Acceptability analysis considering geogrid solutions based on cost-effectiveness, conventional (maximum acceptable rate of fatalities) and utility-based (maximum acceptable investment in mitigation to prevent fatalities) criteria.

The goal of this project is to extend their application to northwest Ohio (P PET equals 1.29) by designing covers that produce a rate of percolation less than 32 cm yr−1, the maximum acceptable rate by the Ohio Environmental Protection Agency OEPAA).

The observed maternal death rate related to abruptio placentae in our study is above the maximum acceptable rate of 1%% [ 7], but the case fatality rate is lower than the 4.7 % that was reported by Seema et al. [ 6].

The maximum acceptable rate of inappropriateness should be below the rate for the total period of hospitalization which, for the hospital and period under consideration was 34.2% (CI95% 33.3 35.1) [ 13], even though no standards have been set in this sense.

Given that intubated patients with IPF exacerbations require high-minute volume because of increased dead space, the respiratory frequency should be increased to the maximum acceptable rate and the target of a normal PaCO2 (arterial partial pressure of carbon dioxide) should be abandoned.

The maximum acceptable rates of complications and conversions, however, were lower among nurses as among patients.

An exact trigger rate for a potential recall could not be identified from published sources, but historic event rates indicate a maximum acceptable failure rate of 1.5% during 24 months.

From 2006 to 2009 the difference between the real and maximum acceptable error rate decreased; however, by the end of the study period in 2009 the error rate (7.87%) remained above the 5% threshold.

That is what China's State Council, or cabinet, has been saying for months is the maximum acceptable inflation rate.

This is a more sensible use for the AD, as it would be up to the end user to select the maximum acceptable error rate level.