Sentence examples for maximal fluorescence at from inspiring English sources

The fluorescence signal is normalised cell-to-cell and region-to-region by calculating the maximal fluorescence at the end of the experiment upon complete mitochondrial depolarisation (achieved by FCCP treatment).

Both FRET systems had a small maximal fluorescence change at saturating glucose (7% and 16%), badan attached at C152 was associated with a 300% maximal fluorescence increase with glucose, though with badan at C182 there was no change.

G-PS1 transfected cells (negative control) showed maximal fluorescence emission at 513 nm.

Ofloxacin in PBS (pH 7.4) showed a maximal fluorescence peak at 460 nm (range 390 600 nm) as shown in Figure 1.

The analysis of the bacterial samples further confirmed that the transformant bacteria exhibited strong levels of brightness (a maximal fluorescence emission at 495 nm upon excitation with the blue light) similar to the levels previously reported for the FbFP expression in E. coli and C. albicans [7].

FRAP curves were quantified measuring maximal fluorescence intensity at the bead's rim in the bleached region.

3The concentration of free NAD+ was determined using eq 4. 4The value of θ is obtained from the fluorescence measurements [(F0 – F /(F0 – Fmax)], where F0 is the fluorescence intensity without NAD+, F is the fluorescence intensity in the presence of NAD+, and Fmax is the maximal fluorescence intensity at saturating NAD+ concentrations.

Finally, fluorescence was measured after 30 min of incubation at 37°C using a microplate Fluoroscan Ascent spectrofluorometer (excitation at 540 nm and emission at 590 nm), as preliminary experiments have shown that maximal fluorescence was obtained at that time independently of the dose of squalamine.

For calculating mole fraction partitioning coefficients (Kdx), the maximal fluorescence intensity (F at λmax) was measured and normalized to the zero lipid fluorescence intensity (F0).

Furthermore, T selectivity (T/NS) after topical ALA at the interval of maximal fluorescence was higher than at the interval directly after application.

All the maximal fluorescence intensities were observed at around pH 2, but slightly different.