Sentence examples for maximal cooling from inspiring English sources

CTs are selected when the maximal cooling load is desired and under the worst design conditions.

Our study may shed the light on various thermal-system designs that desire either maximal insulation (e.g., storm windows and energy storage) or maximal cooling (e.g., LED and other electronic devices).

For freeze fracture and deep etching, the requirement for a larger specimen size precludes true vitrification throughout the specimen because the maximal cooling rate possible within the sample is limited by the rate of heat conduction through it.

The target temperature was usually 33°C, and a maximal cooling rate was typically chosen.

All patients were cooled using either Alsius Coolgard 3000™ (Zoll Medical Corporation., Chelmsford, MA, USA) or Arctic Sun™ (Medivance, Inc., Louisville, CO, USA) with the maximal cooling rate until the target core temperature of 33°C.

Risk increased with increasing maximal temperature, but decreased with cooling degree days, indicating a threshold of 18°C above which the qualitative effect of temperature changed.

Chromatin was solubilized on ice with a probe sonicator (MSE, Soniprep 150) by 3 cycles of 15 sec pulses of half maximal power with 30 sec cooling time between pulses.

It has a low time constant of thermal cycling, with the maximal heating rate over 15 °C/s and cooling rate at around 10 °C/s.

30 minutes of cooling (10°) showed improvement of maximal isometric grip strength immediately after the application of cold but decline by the end of treatment.

Each session included 10 min of warming up with slow walking and easy movements of progressive intensity, 10 min of aerobic exercises at 60 65% of maximal heart rate, 20 min of overall mobility and lower limb strength exercises using water resistance, another set of 10 min of aerobics at 60 65% of maximal heart rate, and 10 min of cooling down with low intensity exercises.

Four mesh strategies are generated for the grid independence check; their maximal cell edge lengths Δd on heating and cooling walls are 4 mm (Figure 2A), 3 mm (Figure 2B), 2 mm (Figure 2C) and 1 mm (Figure 2D).