Sentence examples for max corresponding to from inspiring English sources

The current (I max) and the voltage (V max) corresponding to the maximum power point are then obtained.

We notice that starting from q 1, the maximum discount factor of the cross-layer model converges to λ max corresponding to the Goodman model.

Simulations show that it exists a packet arrival rate q 1 before which the λ max corresponding to the cross-layer model takes higher values than the maximum discount factor of the Goodman model for different numbers of users.

Comparative protein analyses showed that there are four cysteine desulfurase genes in G. max, corresponding to loci Glyma01g40510, Glyma09g02450, Glyma11g04800 and Glyma15g13350.

We refer to the eigenvector u max corresponding to the largest eigenvalue λmax at a given frequency as the principal mode of oscillation for that frequency and the coherence of electrode sites was obtained by the absolute value square of the eigenvector (Purdon et al., 2013).

The only exceptions were region I (north region, latitude 19.73° S) and regions X and XI (41.49° and 46.42° S).> -wrap-foot> Latitudenotesthe the latitude of the centroid of each region, max Dk is the maximum value observed for the Dk statistic and Year (max Dk) corresponding to the year when the maximum is observed The time series at the national level is shown in Fig.  2a.

The maximum SINR target ζ max corresponds to the maximum generalized eigenvalue of A and B, when the receive filter γ is chosen as the corresponding generalized eigenvector γ max i.e., A γ max=ζ max B γ max.

Two alert thresholds were defined for Ile-de-France as 31°C (T max) and 21°C (T min), corresponding to an increased risk of mortality of 50%.

Then the Eopt bess-max(i) corresponding to the maximum value of R sum with the P pv-for (k) and i-th P pv_act (k) is calculated based on GA.

Also, because the calculated experimental value of the max bond stress corresponding to crack D (see Fig. 4) was greater than the allowable value, a concrete cover delamination failure was also eminent, but did not occur.

To address these shortcomings, experiments evaluating the sedimentation behavior of nZnO dispersions were performed by measuring changes in the optical absorbance intensity at λ max (~378 nm corresponding to the band gap energy of nZnO) relative to the initial absorbance intensity.