On the base of superposition theorem of elasticity and compression experiment of the pipeline material, the minimum mean contact pressure of 8.625 inch SPMC is calculated.
The investigation includes aspects such as the efficacy of a single layer of material, the minimum number of layers of linings to achieve the minimum overall thickness for low (100 Hz), mid (250 Hz) and high (500 Hz) cut-off frequencies, the use of the three-layered lining composite for low to mid cut-off frequencies and the effect of air gaps.
However, for mapping chromosomes in mitosis in the same material, the minimum resolution required to distinguish the sequences was 2 Mb (Cheng et al. 2002).
In a study addressing microarray sensitivity using non-amplified material, the minimum transcript concentration that provided reliable measurements was defined to be the interception between the distribution of signal intensities, with the distribution of signal intensities from differentially expressed genes [ 38].
With the increase in the product of thermal conductivity ratio and the square of elemental high conductivity material fraction, the minimum dimensionless thermal resistance of the first order disc for structure form nn decreases, but that for structure form nb is undetermined.
However, all the materials evaluated presented the minimum radiopacity required by the ISO standard (Fig. 2b).
The influence of hydrolysis time and solids loading on the hydrolysis yields of the pretreated materials and on the minimum protein required to achieve efficient hydrolysis were next assessed.
However, as the material density increased, the minimum fluidization velocity increased.
Critical surface tension of a material surface is the minimum value of surface tension needed for a liquid to spread completely (i.e., zero contact angle) on that particular surface material.
The proposed method incorporates the Finite Element simulations into a Genetic Algorithm framework that aims to yield a multi-material part, with the minimum possible weight, whilst satisfying the imposed design requirements.
