Sentence examples for materials ratio of from inspiring English sources

Impact of NWPA on performance of mortar with water to cementitious materials ratio of 0.3 was presented in this paper.

Mortar mixtures were prepared with a water-to-cementitious materials ratio of 0.60 and a cementitious/sand ratio of 1 3.5.

The optimal synthetization of WER microcapsules that 0.5% emulsifier dosage, emulsification for 16 min, core-wall materials ratio of 1.3 1, and the optimal synthetization of CA microcapsules is that 0.7% emulsifier dosage, emulsification for 16 min, core-wall materials ratio of 1 1.

Water-to-SCMs ratio (by weight) of 0.47 and the graded aggregates to total cementitious materials ratio of 2.15 were used.

Thirty three different types of ternary and binary cementitious mixtures including the control mixture of 100%% ordinary portland cement with a water/cementitious materials ratio of 0.44 were designed to give a wide range of values for this experimental program.

Additionally, according to Federal Highway Administration (FHWA), it is defined as a cementitious composite material composed of an optimized gradation of granular constituents, a water-to-cementitious materials ratio of less than 0.25, and a high percentage of discontinuous internal fiber reinforcement (Graybeal 2011).

The morphologies of 3D nanostructure can be controlled by adjusting the raw material ratio of pyrrole to GO.

Nine concrete mixtures were designed to have the same degree of workability and air content with water/cementitious material ratio of 0.4.

The optimum extraction parameters predicted were 93% ethanol concentration, for 4.3 h at 43 °C and a solvent to raw material ratio of 1/66.

Then, the optimal parameters of MSCE were obtained by using single-factor experiments and Box Behnken design (BBD) as follows: extraction temperature of 46.6 °C, CaO to raw material ratio of 6 100, water to raw material ratio of 8.8 1 and extraction time of 51.7 min.

Limestone rock fine and coarse aggregates were mixed in the concrete with a water/cementitious material ratio of 0.33 for early adequate strength.