Sentence examples for materials a value of from inspiring English sources

For the crosslinked materials, a value of the monomer:initiator ratio was established which gave homogeneously cured materials.

where CA is the specific areal capacitance (F cm−2) calculated from the charge-discharge curves; d is the thickness of the active material, with a value of ~3 × 10−4 cm for a single MSC in this work; ΔV is the applied voltage (V); and Δt is the discharge time (s).

The separation was followed by the increase in intensity of new lines in the ultraviolet spectrum and by a steady increase in the apparent atomic weight of the material until a value of 225.2 was obtained, remarkably close to the currently accepted value of 226.03.

Mass spectrometry analysis of the purified material yielded a value of 32,201 Da (predicted mass: 32,202 Da).

Analyses of FAPAS #T3021 material (assigned a value of 862 ng g−1) gave a mean acrylamide concentration of 840 ng g−1 with a standard deviation of 54 (n = 46) and RSD of 6.4%.

After the final adsorption step the density of the residual adsorbed material jumped to a value of 0.45 g/mL and, the thickness dropped from 25 30 nm to 7 8 nm (data not shown) implying the mucin was relatively flat on the surface.

In this case, the localization index defined in 'Materials and methods' adopts a value of ∼3.7.

Basically, a scalar damage variable is used to represent the overall damage in the material, which initially has a value of 0 and monotonically evolves from 0 to 1 upon further loading after the initiation of damage.

Selection 'F8,1-42 'F8,1-42ts introgression of genetic material from almond, exhibited a value of 1.4347, withh was more sitslar to the more dintrogressionof cultivar.

For the group provided with handouts (group B) the students spent a median time of 3 (ie about 2 hours in total over the nine weeks) (interquartile range 3 4) on the material and gave it a value of 2 (interquartile range 1 2) (ie valuable).

In the case of bulk materials, a maximum value of equivalent plastic strain and hardness is higher for the Berkovich indenter than for the Vickers.