Sentence examples for material sintering from inspiring English sources

The yttrium oxide (Y2O3) powder is used as a raw material for single-crystal growth and for yttria ceramic material sintering.

Properties of ferrites, including electrical, largely depend on their microstructure, which is determined by the degree of dispersion of the material, sintering temperature, time, and conditions of synthesis and composition.

The fluidized bed reactor configuration can potentially minimize problems associated with material sintering but the average CO concentration and OSM utilization are significantly lower compared to the fixed bed due to the limited operational freedom.

Waste red mud: Zhang et al. (2014b) used the acid activated (Acid treatment neutralize the alkalinity of red mud, which could also be recognized as a method for activating the material) sintering process red mud (ASRM) for the adsorption of MG.

The indentation modulus of the investigated material SPSed at 1550 °C was 288 GPa and 300 GPa for the material sintered at 1650 °C (Table 3).

Cerabone (AAP Biomaterials GmbH, Berlin, Germany) xenogenic granulate is a bovine bone material sintered at high temperature (>1200°C), which retains the inorganic part of bone (hydroxyapatite) [ 38 ].

In spite of materials sintering, the oxygen releasing/acquiring capacity and reactivity of Fe-Ce mixed oxides are three times higher than that of pure iron oxide after redox treatment.

Tang et al. reported the layer nanostructured Bi2Te3 bulk materials sintered by spark plasma sintering and combined melt spinning technique, and obtained the highest ZT value of 1.35 at 300 K [6].

Marble sludge waste was used as a major cement raw material in sintering sulfoaluminate cement clinker successfully in the laboratory.

Bonding of silicon nitride powders can be achieved at lower temperatures through adding additional materials (sintering aids or "binders") which commonly induce a degree of liquid phase sintering.

The higher amount of aluminum in implants 1, 4, and 5 might be due to the individual material composition while sintering the material mixture or to corundum particles of the machining and sandblasting process.