Sentence examples for material for typical from inspiring English sources
The aim of this paper is to computational analysis of prepared crowned tooth in order to differentiate the possibility of using porcelain material for typical clinical condition and masticatory load by using the three-dimensional finite element method (3D FEM).
This report provides information for the selection of structural materials for typical nuclear reactor coolant systems when selecting liquid lead or lead bismuth as heat transfer media.
A series of performance indices are given to allow a wide range comparison of materials for several typical sensing and actuating structures, and a rapid identification of candidates for a given task.
Recently, new duplex surface treatments involving the use of packing diffusion, electroplating and plasma nitriding have led to the possibility of using this material for applications usually typical for tool steels.
The character of the magnetic susceptibility χ(T) curve for the source material is typical for NCM containing a substantial amount of nickel.
For typical material properties, it was found that cavity coalescence begins at low cavity volume fractions (∼1%), independent of the individual, isolated cavity growth rate and the cavity nucleation rate N.
Although the proposed method is order dependent and requires a priori information on material ordering, it is suitable for typical contact line applications, where the material representing the contact surface is always known.
This paper presents a review of the current situation and state-of-the-art recycling methods for typical materials and components of fusion plants based on current conceptual design studies.
Initial calculations have shown that the microstrip line cable geometry for typical materials employed in production of HTS thin films can be a two-layered film for which the two layers of about 10 cm long are separated by an insulation layer with as low permittivity as possible.
Steel pipes with D/t ratio and material grade typical for oil and gas pipelines are considered.
The physical, geotechnical and chemical properties of these construction and demolition materials were compared with local engineering and water authorities specifications for typical quarried materials so as to assess their performance as a viable substitute for virgin quarried aggregates in pipe backfilling applications.
