● Primary intra-caldera material deposit volume and DRE volume.
Material deposited at the bottom of the concrete mixer consisted mainly of sand, fragments of rock, and pyrite nodules, which was free of amber, revealing the efficiency of this method in processing large quantities of amberiferous rocks.
Polycrystalline films deposited on substrates generally show preferred orientation, with a strength which depends on the deposition method, film material, and deposition conditions, including residual gas pressure.
In terms of microscopy, SEM and TEM are preferred; however, the advent of high speed AFM imaging technologies will likely promote AFM as an equally acceptable method for well-constrained materials deposited on atomically flat substrates.
Furthermore, PAAs with ultrasmall nanopores have advantages over other methods to fabricate quantum dots and wires due to its low cost, high regularity, high sheet density and less requirements on depositing materials and methods [1, 3].
This active material was deposited using spray method.
An amorphous Si (a-Si) as a resistive switching material was deposited by PECVD method.
Generally, considering the uniformity and controllable thickness of the material to deposit, atomic layer deposition (ALD) technology is an effective method to deposit high-k gate dielectric.
Genome assembly scaffolds and annotation were deposited under the accessions CCYD01000001-CCYD01003162. Additional file 1: Additional Material and Methods section.
Sequences between 20 and 24 nt were pooled and each set of sequences was analyzed by BLAST [79] against the nucleotide sequence of HSVd and GYSVd1 variants cloned and sequenced in this study and of variants of these viroid species previously reported on grapevine and deposited in databases (Materials and Methods S1).
