Sentence examples for material debris from inspiring English sources

The world's television media seemed oblivious to the irony of criticising the chaos while contributing to it – wading through fields to get a better shot with little regard for the human and material debris below.

Approximately up to 2 m from the ground surface, there exists a layer of very loose material (debris).

A sensitivity analysis showed that fine sediment is most sensitive to variables related to the texture of the source material, debris flow volume estimation, and the proportion of fine sediment transported to the reservoir.

"They'll know what's not there, and I don't think it's possible to completely sanitise the site from any material debris that would have come from a missile hit, or rather a missile miss because these missiles are not designed actually to hit aircraft, they explode close to them".

The application of the hydrolysis protocols listed in Table 1 resulted in two basic types of cytological preparations: (i) slides with mostly intact PMCs with well-spread cytoplasm and no callose layer and (ii) slides with similar PMCs but in which the callose was only partially hydrolysed, i.e. some callose and residual digested material (debris) remained.

The total volume of coarse-material debris flow deposition in the channel appears to be larger than that of fine-material debris flow deposition.

Sediment deposition of fine-material debris flow begins further downstream with an approximately 3° higher surface slope compared to the case of coarse-material debris flow.

Thus, the deposition area of coarse-material debris flow reaches further upstream in the approaching channel than that of fine-material debris flow.

The collected water samples from the two sites were first filtrate by Whatman GF/C, 0.6 0.7 µm pore size membrane filter to avoid unnecessary large-sized particulate materials (debris) that cause further nutrient release before nutrient analysis was made.

Cells or other insoluble materials (debris, crystals and aggregated materials) were cleared from the samples by centrifugation at low speed (2500 rpm, 1 h at 4°C), then 5 ml urine sample aliquots were transferred in polypropylene tubes, lyophilized, and stored at -80°C until their usage.

Choose a suitable site to work from: flat, level and free from loose materials, debris or rubble.