Sentence examples for material contact area from inspiring English sources

This research seeks to engage the frictional characterization of the small bowel with a formally designed experiment which samples the variability within the porcine animal population while parameters such as engineering material, contact area and bowel region were varied.

To control the electrical charge of the droplet, along with the use of less ionizable material, the contact area between the aqueous solution and pipet tip inner surface can also be controlled by changing the geometric design of the pipet tips because the contact area is one of the key parameters on the contact electrification phenomenon.

This modification at a certain extent decreases the interface area between synthetic material and contact area leading to reduction in the amount of prime volume of the system [ 11].

The net charge is a function of the materials in contact, area, the environment, and dissipation processes which depend on the ambient conditions, the materials and the presence of ground planes.

The enhanced electrochemical performance is mainly attributed to the introduction of carbon flake shell in the core/shell nanowire arrays structure, which provides higher active material-electrolyte contact area, improved electrical conductivity, and better accommodation of volume change.

Figure 14 Average errors in whole-body tactile sensing capability with soft material and highly rigid material in contact areas.

The effect of the differences in strain morphology between the homogeneous PDMS material and the bilayer material on the contact area is not immediately obvious.

It includes the effects of conduction through the solid material and contact areas between spheres, conduction through the stagnant gas phase as well as thermal radiation between the surfaces of the spheres.

Therefore, in this paper, we propose a whole-body tactile sensing system using a force sensor with soft material in contact areas.

This is usually done through the use of special materials in the contact area between the wheel and rail in addition to increase in the coefficient of friction [40].

Most common saturation towers use packing material to increase the contact area between compressed air and water.