Sentence examples for material average from inspiring English sources

Material Average particle size (nm) Solid contents Viscosity (cps) Ionicity pH Appearance SB Latex 184.6 47.1 384 Nonionic 9.5 White liquid.

For the NR tested, the obtained characteristic time is around 20 ms when the material average elongation during the cyclic test is above a critical elongation value λc.

However, the material, average particle size, and NCBM morphology within these four samples (P1 P4) were dissimilar; therefore, the enhancement rate of the thermal conductivity did not necessarily increase with a rising concentration of NCBMs.

Finally, the mean TVOCs emission rate and the residual TVOCs percentage within the building material, average concentration and average ventilation effectiveness at the different locations of the room with respect to time are also investigated.

The concept of subRVE (sub Representative Volume Element) is introduced as a smaller constituent unit of RVE (Representative Volume Element) and with the dimension of material average grain size for the purpose of considering the heterogeneous damage in the RVE.

In addition, electron energy loss spectroscopic (EELS) analyses have revealed that micrometeorites yield higher concentrations of carbonaceous material (average C content is ∼7 wt%; Engrand and Maurette, 1998) than carbonaceous chondrites (average C content is ∼2.5 wt%; Engrand and Maurette, 1998).

The statistics class started with easy material: averages, means, medians.

For larger engineering-size specimens that include millimetre-size pores, the strength of the material averages about 20 MPa (an elastic modulus of about 11 GPa).

4-2a contained residual plant material averaging 41.2 ± 1.4% relative to the weight of the original plant material (58.8% solubilization).

In general, each of the three nonlinear models (exponential, Michaelis-Menton, and power) tended to give similar results in terms of RBA value (the SD in RBA for a particular test material averaged across the three models was usually < 3%), and differences in the AIC were usually small.

By comparison between the Chinese loess and its source materials, average HIRM values from TK, QH, QD, and HB are significantly lower than for loess.