The lesion profiles of both groups inoculated with scrapie material and comparisons with corresponding data from brains of cattle i.c. and naturally infected with BSE are given in Figure 1.
The paper is focused on the condensation and freezing in the material and includes comparison with the authors previous studies on stone-wool insulation.
The strength design of heat-transfer surfaces composed of transverse finning tubes, in general, refers to the determination of the allowable wall thickness of the finned tubes, corresponding to the operating conditions and the selected material, and its comparison with the nominal wall thickness, assumed beforehand in constructive characteristics of the heat-transfer surface.
Consequently, the data presented and discussed here are mainly based on the analysis of the 'trichome-enriched' material and its comparison solely with the 'trichome-depleted' sample material, as the technical replicate analysis of these samples showed a similarly low relative standard deviation of around 2.5 % for the number of identified proteins.
Finally, given the generally low Kappa values observed in our study, further research on the validity of a residential value index as an individual indicator of material circumstances and comparisons between individual and area-level residential values are warranted.
The experimental program aimed the characterization of the base materials and the comparison of the performance of wood beams with distinct reinforcement lengths and beams without any reinforcement.
And we added the following to the Materials and methods (Comparison of gene expression and embryonic lethality data): "To test whether native gene expression of our target genes correlates with the embryonic lethality phenotypes, we downloaded microarray transcriptome data published by Grishkevich et al. (2012).
After the two-round hybridization selection (details see Materials and Methods) and comparison with the genome-wide physical contig map, a total of 5,005 positive clones were identified for fingerprinting.
As so, we determined the average of cells detected by cultivability on each biofilm for the 6 materials (Figure 6.BI) and comparison showed that these values were much higher than those obtained for copper (Figure 6.BII).
Consistency of the data in our registry, which have been externally assessed as described in Materials and methods, and comparison of drug survival in different conditions offer a unique opportunity for the detection of relevant differences in safety and effectiveness.
