Sentence examples for mass shrinkage from inspiring English sources

The system pickup efficiency, specific moisture extraction rate, dimensionless mass loss, mass shrinkage ratio and drying rate are discussed in this paper.

We would anticipate that future treatments capable of producing tumor mass shrinkage would be reflected as an even greater response in tumor ADC values, and that this strategy would serve as a foundation on which to non-invasively monitor novel treatment protocols.

Subsequently, the oncologist who was responsible for delineating GTV0 and CTV0 further modified and recorded the following weekly GTV and CTV according to anatomical changes and mass shrinkage.

Circulating thyroid hormone levels were normalized in more than 95% of patients, and pituitary tumor mass shrinkage occurred in approximately 40% of patients [ 12].

So far, conditional disruption of Dicer, a key miRNA processing, may lead to impaired adipogenesis and fat mass shrinkage [ 16], reinforcing the relevance of miRNAs in AT development, inflammation, and metabolism.

The alternative policies included five well-known predictors of necrosis in addition to residual mass size (primary tumour histology, prechemotherapy levels of the three tumour markers alphafetoprotein (AFP), human chorionic gonadotropin (HCG) and lactate dehydrogenase (LDH) and mass shrinkage during chemotherapy).

The results show that incorporating HMNS mitigates dehydration induced mass loss and volume shrinkage of the geopolymer samples between room temperature and 250 °C, and increases their residual strengths when exposed to high temperatures between 600 °C and 800 °C.

Although some pores were observed inside the film of the Ag nanopaste, the main parameter was the volume shrinkage of the screen-printed Ag film compared to the mass decrement caused by the solvent evaporation.

Tests were undertaken with a small oven within a test machine measuring mass loss, shrinkage, bending strength, and modulus of elasticity at elevated temperatures.

It was found that the introduction of electroplating sludge reduced the bulk density and compressive strength, and increased the mass loss, linear shrinkage, porosity ratio and water absorption.

It is shown by independent measurements that significant changes in pycnometric density, mass loss, and shrinkage all occur in the same temperature range (800 1200 K).