Sentence examples for mask surface from inspiring English sources

This behavior may be attributed to the presence of high concentration of dangling bonds in α-Si mask surface.

Supporting the ToF SIMS observations relating to the solder mask surface chemistry, the concentrations of the elements carbon, oxygen, nitrogen and silicon on the solder mask surface, measured with XPS on the solder mask surface for quantitative information, showed no significant variance as presented in Table 2.

As displayed in Fig. 2 (right), the copper content decreases rapidly within the solder mask to approximately 22 wt% and decreases slightly towards the solder mask surface.

Slow drying, by the presence of a biofilm barrier "coating" the mask surface, is a process more likely to bring dissolved salts to the surface [35].

For a 44.88 µm-diameter microstructure illuminated with a linearly x-polarized beam, a 5.77λ-long unifopticalical needle is produced at a distance of 12.88λ away from the mask surface.

The EDS line scans exhibited the presence of copper within the polymer network with decreasing content from the copper/solder mask interface up to the solder mask surface (Fig. 3).

At the end of the above described process stages, adhesive bonding to the solder mask surfaces usually takes place.

Reproducibility of the solder mask surfaces was confirmed by distribution patterns (5 mm × 5 mm) with ToF SIMS.

However, the mask patterns formed by these methods are mechanically produced at higher load and stress, damaging the mask surfaces and creating an oxidation layer that decreases the etching rate achieved with KOH solution.

To include the influence of this special wet bath chemistry in our research, the solder mask surfaces were treated with a commercially available OSP, based on benzimidazole chemistry [15, 16].

These data indicate that masking surface charges on contrast agents is a useful strategy to improve imaging efficacy.