Since the position of the GPS satellites is also a function of the elevation and azimuthal angles, we can compare the two data sets without any assumptions on the mapping height.
Namely, loose restraints based on the cryo-ET maps (height = 10 ± 2 nm, width 26 ± 2 nm, inner radius = 8 ± 2 nm) were imposed to ensure the height and width of the assembly to be smaller than, respectively, 10 nm (maximum extension of YscD prior unfolding) and 24 nm (the PrgH rings features a width of about 27 nm).
A contour map of height would represent a spiral staircase (or, better, a spiral ramp) by a similar many-valued contour.
After that, in order to obtain the distribution map of height value, we change the length of baseline and its relevant parameters (i.e., θ 1, θ 2, α), but keep the other parameters unchanged.
(An interactive map of height evolution worldwide can be found here).
In this study, we applied joint linkage and GWAS approaches to map plant height and flowering time QTL in a population of five sorghum F3 families (A E).
Here again we show a surface map in height and θ and have located the blobs with outlines as shown previously.
We explored the use of genotyping by sequencing (GBS) on a recombinant inbred line population (GPMx) derived from a cross between the two-rowed barley cultivar 'Golden Promise' (ari-e.GP/ Vrs1) and the six-rowed cultivar 'Morex' (Ari-e/vrs1) to map plant height.
Finally a regionally-tuned equation is applied to relate mapped canopy height to ACD [26], resulting in a carbon density map at 30-m resolution for the entire island chain.
Finally a regionally-tuned equation is applied to relate mapped canopy height to ACD [ 26], resulting in a carbon density map at 30-m resolution for the entire island chain.
