Sentence examples for manual assembly and from inspiring English sources

Sanger reads and pyrosequencing contigs initially were assembled with CAP3 [ 78], then manual assembly and in-house scripts were used to piece the contigs together with the Sanger read-pair information.

However, some of the smaller, fussier bits are made by hand in the U.S. Gas tanks, for example, because of strict emissions laws, are surprisingly complex and require a lot of engineering and manual assembly and are often made in the U.S. A gas tank might be relatively cheap and light, but for American workers it's worth a lot more than many tons of steel.

Manual assembly and inspection are used in major operations in the factory, but new automatic equipments are developed for replacing these manual operations.

The moderate current capacity was the result of the manual assembly, and can be improved with wire-bonding technology and adoption of coils from commercial vendors.

RF performed the manual assembly and annotation of EST datasets.

Only high-quality discrepancies were individually investigated through careful manual assembly and editing.

The main idea of Interactive Manual Assembly Operations for the Human-Centered Workplaces of the Future (INTERACT) project is to utilize workers' knowledge on executing manual assembly tasks and include it in the digital tools used to support manufacturing and continuous improvement of human-centered, flexible assembly workplaces.

This paper presents a Knowledge Based Design Methodology (KBDM) for automated and manual assembly lines, which can be applied equally well to single, multi- and mixed-product assembly lines with either deterministic operation times or stochastic operation times.

The experiment used existing interruption coordination methods as a basis, and the results showed a difference in the effect of interruptions and interruption coordination between cognitively complex laboratory tasks and manual assembly tasks in an authentic environment.

Two case studies are presented: a workplace for stud welding and a set of two workplaces, for hole drilling and manual assembly.

The 3-D mask was fabricated by silicon deep-etching of a 500 μm-thick silicon substrate, and manual assembly process.