Sentence examples for making close contact from inspiring English sources

In the present case, the ZnO structure-covered superhydrophobic surface is capable of making close contact with water droplets due to large van der Waals' forces, similar to the effect of the gecko's foot hairs.

When the peristome is wet, the fluid films prevent the insects' tarsal adhesive pads from making close contact with the surface, similar to the aquaplaning of a car tire on a wet road.

The benzo[1,3]dioxole moiety is deeply buried, making close contact with Ala397 and Gly232 at the bottom of the cleft.

The two regions in the PBD making close contact with the C-terminal domain, residues 263 268 (loop) and 304 314 (α helix), do not show significant ΔD% between the monomer and dimer.

However, in the MOE preparation, the selected pyrrolidine conformation is different and led to an obvious deviation in the placement of enalaprilat's carboxylate group, thus, making close contacts with the surrounding polar residues infeasible.

Then we insert lysine K85 next to the major groove of DNA at the dyad axis, as it was found to be in 27 out of 30 top-ranked docking positions [28], and oriented the globular domain so that the residues involved in DNA binding (R42, R47, R73, R74, R94, K40, K69, K85, K97, H 25 and H62) are making close contacts with the entry and exit linkers.

acidophila LH2 complex shows the basis for this structural role; nine membrane-spanning carotenoids traverse the membrane, making close contacts with both the nine B800 and eighteen B850 BChls [7].

The extracolumella lies below the surface, where it makes close contact with and finally enters a dense layer of the skin.

As it is, "The Punch" carries more padding than an N.F.L. quarterback, repeats itself regularly and rarely makes close contact with its two central figures.

Microbial biofilms make close contact with the substrate, and thus probably cause significant deterioration of the underlying materials.

In order to make close contact with the TiO2 porous film, the polymeric electrolyte was prepared by photo-polymerization after injecting the monomer electrolyte solution into the porous film.