Sentence examples for main peak frequency from inspiring English sources

For lattice angle = 5° and 14°, both of the experimental main peak frequency is 4. The simulation main peak frequency is 4.6 with lattice angle = 14° and 25°, but the ratio values are much different.

Although the main peak frequency is with less error, it cannot be used as a factor to determine the orientation.

In addition, we can still compute the atrial rate, that is, the main peak frequency, although again we cannot measure its goodness in absolute units.

From the lead with higher AA, usually V1 [12], the main peak frequency is estimated using the Iterative Singular Spectrum Algorithm (ISSA) [15].

where Pa(f) is the power spectrum of the extracted atrial signal x ^ A ( t ) and f p is the fibrillatory frequency peak (main peak frequency in the 3-12 Hz band).

From ISSA algorithm, we obtain an estimation of the main peak frequency of the AA, f ˜ p, and then we convert it to period using the expression P ˜ = 1 ∕ f ˜ p. In the experiment, we varied the initial estimation of the period measured in samples, referred to as i P ˜, from i P ˜ - 20 samples up to i P ˜ + 20 samples.

Then the wave source spectrum has the main peak at frequency k x c x. Figure 1 shows examples of frequency spectra (in relative units) of the wave forcing (2) calculated using sliding intervals at different times t after activating the wave forcing.

Consequently, the main peak at the frequency of bursting survives (Figure 7c2, red line).

As can be seen, both of them show a power spectral density concentrated around a main peak in a frequency band (narrow-band signal).

The main peak at high frequency (684 cm−1) is the characteristic peak of the spinel ferrite attributed to A1g mode which corresponds to the symmetric stretching of oxygen ions along the Fe–O bonds at tetrahedral sites [17].

A peak with highest frequency is a main peak, while peaks of lower frequency are side peaks.