Sentence examples for machine tool characteristics from inspiring English sources

According to these considerations the proposed tool allows to quickly and easily analyze alternative design solutions and makes possible to optimize the dynamic performances of the machine tool, helping the designer in the definition of the optimum machine tool characteristics before the manufacturing of the physical prototype.

However, due to relatively harsh environment in the machine tools, metrology characteristics of surface measuring instrument would deviate from those tested in laboratories.

Figure 1 shows the schematic diagram of the experimental setup which deals with the equipment used for measurement of different performance characteristics, selected machine tool, cutting parameters, cutting tool material, statistical method for machinability investigation and scanning electron microscope for observation.

This paper presents a method for identifying the dynamic parameters, as well as the friction characteristics of machine tool drives.

For example, friction characteristics of a machine tool become highly non-linear at low operating speeds, demanding sophisticated compensation.

The machining performance is determined by the frequency characteristics of the machine tool structure and the dynamics of the cutting process, and can be expressed in terms of a stability lobe diagram.

Traditionally, the thermal contact resistance between solid joints and the change of the heat generation power with the bearing temperature are often ignored when thermal characteristics of a machine tool spindle are analyzed.

As the thermal error transfer function can be deduced using Laplace transform, the thermal error characteristic of the machine tool can be studied with both time domain and frequency domain methods.

The problem of fitting the characteristic of the universal machine tool's main drive to anticipated machining tasks is considered.

According to the orthogonal experiment method, four configuration parameters of machine tool are considered as four factors for dynamic characteristics.

Therefore, the force analysis of typical overconstrained systems (for example, the parallel machine tool XT 700) under the condition of the actual characteristics will become a research hotspot.