Sentence examples for machine response from inspiring English sources

The proposed technique is also well suited to computing efficiently the machine response to unbalance by using a truncated modal decomposition.

k At a (faster) time scale of machine response.

However, sitting in front of a computer screen at the Royal Society last Friday, I had little doubt that spotting machine responses would be obvious.

Testing novel harvest technologies using the virtual environment of the combine simulator introduces a specific set of constraints and challenges that are not found in most other vehicle simulation applications, including the need for accurate physical and visual crop flow representations and a requirement for realistic machine responses to a wide variety of operator input commands.

That was often why it was easy to get expert systems to fail the Turing Test, as the way people could twist language to confuse the systems and stilted, basic machine responses meant it was easy to tell that the conversation was with an expert system and not a human.

Finally, algorithms are developed to invert this design to realistic local controllers in each area by optimizing the controller parameters until their interarea response matches the closed-loop inter-machine response achieved in the second step.

The result from this study shows that the application of the Taguchi method can determine the best combination of machining parameters that can provide the optimal machining response conditions which are the lowest surface roughness and lowest cutting force value.

In the present study, weighting factor of 0.5 for each of the machining response characteristics is considered, which gives equal priorities to both MRR and Ra for simultaneous optimization (Chalisgaonkar and Kumar 2013).

At last, it is verified that the computational accuracy and efficiency of MSMOMDAM-DSM isuperioror to support vector machine-response surface method (SVM-RSM).

Comparison of machining responses showed a close agreement between finite element and experimental studies.

The design of experiments was used to conduct the experiments to evaluate the effect of the feed rate on the machining responses such as surface roughness and cutting force components using a face milling operation during the cutting process of the titanium alloy (Ti 6Al 4V).