Sentence examples for machine defect from inspiring English sources

Experimental studies using rolling bearings that contain different types of structural defects have confirmed that the developed new technique enables high signal-to-noise ratio for effective machine defect identification.

Furthermore, in driving the use of a DM strategy for the maintenance of machines used in manufacturing industries, Bouillaut et al. (2008) developed a dynamic maintenance model that could be used to ascertain rail degradation rates and the behavior of various actors involved in machine defect detection.

This chapter provides the methods of correlating rotating machine defects to vibrations collected and displayed by the various types of analyzers.

This paper introduced typical machining defects and studied the machining characteristics of honeycomb core.

During machining CFRP, severe machining defects, such as delamination, burrs and subsurface damages etc., usually occur due to the prominent anisotropy and heterogeneity of CFRP.

Specifically, research is focused on minimizing/removing contaminants and machining defects during manufacture, improving the precision and repeatability of chemical mechanical polishing, and modeling sustainable, environmentally-conscious manufacturing processes and systems.

Due to the flexibility of one-side-supported thin impeller blades, machining defects such as overcut or undercut frequently occur, especially at the front and rear edge connecting the suction surface and the pressure surface, where the thickness are even less than 0.2 millimeter.

Viryl also says that the machine's defect rate is only one per cent.

In August 2005, the machines' aggregate defect rate - from Microsoft's contract manufacturers Flextronics and Wistron, in their factories in China - was allegedly just 68%.

However, in both cases, stopping criteria have shown low sensitivity to cracks: when the machine stops, defects are very large.

The machine had defects, not the least of which was a clatter so loud that slaves were required to walk alongside to calm the frightened horses.