Sentence examples for m the initial from inspiring English sources

Through applying either HCl (0.5 M) or NaOH (0.5 M), the initial pH value of the dye solution was adjusted to the preferred levels.

The only way to solve this would be by imposing that m<m max, in such a way that however, under this restriction on the values of <span class="lh">m, the initial condition could not be satisfied (Equation 10).

In the case of bottom-hole pressure BHP (3650 m), the initial value of 7735 psi corresponds to the hydrostatic head exerted by the mud density of 1.49 gr/cm3.

Assuming an ejection angle of 45° and a horizontal travel distance of 1000 m, the initial velocity was estimated to be 99 m/s based on a simple ballistic trajectory calculation without air resistance and vertical dip.

The detailed description of COPMA is provided as follows: Initialization: For each transmitting and receiving pair m, the initial index of transmit beamformers for all node pairs is selected as one and the initial transmit powers are set as P m = P max, ∀ m ∈ N. Repeat: Randomly choose a node pair m as the updating pair with probability 1/N.

Within the effective range of this sweet spot, the three cases have designed the same parameter: the well space is 600 m with staggered well pattern, the length of the horizontal section is 1200 m, the initial production rate of the horizontal well is 8 × 104 m3/dand and the initial production rate of the vertical well is 2 × 104 m3/day.

The greater are the initial weights (or the lower the threshold), the smaller is the period (here it is about 16 ms, the initial firing rate is thus about 63 Hz).

This filter erased the artifact just before P100 m (∼70 ms) but the initial response did not disappear.

The initial value of is 6 m and the initial value of is 1 m for extreme cases.

V is the final volume of the extraction solution (mL), and m is the initial weight of leaves (g).

Average (±SD) synaptic current amplitudes were calculated from an area of interest extending between 100 ms to 500 ms. The initial delay allowed the simulation to stabilize and prevented analysis of voltage clamp currents associated with the change of the holding potential.