Sentence examples for lowest formation of from inspiring English sources

In storage, whole extrudates exposed to 76% RH presented the lowest formation of hexanal.

Introducing the CuOx/γ-Al2O3 catalyst into the plasma system also shows the lowest formation of by-products.

Thus, as presented in Figure 3b, the lowest formation of polymeric pigments was observed in the jams prepared with LMAP to a level of 1%.

As a critical parameter, the interface temperature from the space between the thermal desorber unit and the GC has been found to be optimal at 300°C with a high and safe yield for decaBDE-209 and the lowest formation of thermal debromination products (heptaBDEs, octaBDEs and nonaBDEs).

Gas Chromatography (GC) analysis showed a high ethanol conversion at 500 °C, high hydrogen yield and low formation of undesired products as methane and ethylene.

Samples annealed at 600 °C showed lower acetone conversion rate and low formation of mesitylene than that obtained on samples annealed at 400 °C.

This is equivalent to 70% recovery of the initial sugars present in olive leaves, with a very low formation of inhibitory compounds and an important amount of natural products with antioxidant capacity such as oleuropein, hydroxytyrosol and flavonoids.

The catalysts with higher vanadium content are more active and selective, exhibiting a H2S conversion close to 70% after 360 h on stream with a high selectivity toward elemental sulfur and a low formation of undesired SO2.

Known conditions that may prevent the accumulation of acetate in cultures include, disruption of acetaldehyde dehydrogenases, low formation of acetaldehyde coupled with effective oxidation of acetate by acetyl-coA-synthetase or the presence of low amount of glucose in cultures such that respirofermentative growth cannot take place (Postma et al. [1989]).

The low formation of organic acids was assisted by the choice of glycerol as the main carbon source.

As in the above discussion of effects of preheating on removal of total mass, xylan, lignin, and cellulose, most of soluble xylooligomers were swept out of the reactor before any further reactions occurred in the preheating procedure, during which the temperature was lower than the target temperature, thus led to low formation of furfural [ 2].