Sentence examples for lowest decrease from inspiring English sources

For heathland, the decrease was slightly lower, 42%, whereas the lowest decrease was found for grassland, 24%.

The highest increase in flexural strength and the lowest decrease in compressive strength is at 0.5 1.5% for CF if all temperature conditions are taken into consideration.

Activities of ADK was the most affected with a decrease of 91.41 99.54% when compared to the control, while NaR showed the lowest decrease on activities ranging from 11.29 to 92.26%.

The POD activity which could suppress auxin by oxidation was significantly decreased in NPB under heat stress, especially with H2O and NAA treatments, and the lowest decrease was observed with the AOPP treatment compared with their respective control (Fig. 2c).

The highest increase in flexural strength and the lowest decrease in compressive strength are at 0.3 0.9% fiber addition ratio for HPP, at 0.3 0.6% fiber addition ratio for CPP and at 0.9% fiber addition ratio for AR for every temperature.

The most relevant achievement is that a concrete mix with a low content (5%) of rubber particles leads simultaneously to the lowest decrease (5%) in the cyclic strength and the highest increase (52%) in the ductility of RuCFST columns, thus being the most suitable mix to use in seismic areas, where ductility and energy dissipation requirements are mandatory.

MC100 induced a concentration-dependent cytotoxicity but a low decrease in mitochondrial activity with a maximum reduction of 20% when cells were treated with 50 μg/ml MC100.

The composite cryogels could be repeatedly used in the sorption of Cr VI), a low decrease of the adsorption capacity being observed after five consecutive sorption/desorption cycles.

Reusability test showed a low decrease in the removal performance of ZnO-AC due to the mesopore filling mechanism confirmed by BET analysis after adsorption.

Thus, the low decrease in the photocatalytic activity after three uses makes the nanocomposites suitable for applications in which reusability is an important key factor.

The Fe/γ-Al2O3 catalyst showed a reasonable stability, a relatively low decrease of activity (15%) being observed after three successive runs.