Sentence examples for lowest application rates from inspiring English sources

Immigrants from Asian countries have some of the lowest application rates — less than 30percentt of eligible applicants applied from the Philippines, India and South Korea.

In the first experiment, single pulse applications of 0 (control) µg, 133 µg, 266 µg and 400 µg g−1 of -catechin resulted in soil levels that were not detectable one hour later in the control or the two lowest application rates, and 60±20 (1SE) µg g−1 in the highest application rate.

In the first experiment, in which application rates of 0 (control), 133, 266 and 400 µg g−1 of -catechin could not be detected in the control and two lowest application rates, and was measured at 4.3±2.4 µg g−1 at the time seeds were planted, we saw no effect of -catechin on the shoot mass of Bambusa at any application rate (data not shown).

We therefore recommend the use of low application rates of manure when the objective is the microbial stabilization of the residue.

While a thinner material like hay proved to be most effective at high rates (600 g m−2), a thicker material like straw encouraged quick recruitment for these species only at low application rates (300 g m−2).

The characteristics of low application rates, good crop selectivity, low residue and environmental safety exhibited by Protoporphyrinogen oxidase (PPO, EC 1.3.3.4 -inhibiting herbicides have attracted a world-wide research interests.

Bouteloua gracilis, whose recruitment and growth were broadly impaired by mulch, showed an abundant and constantly increasing cover in the bare ground control and in plots with low application rates of hay.

The main-plot treatments comprised high and low application rates of chemical fertilizer, while the sub-plot treatments were water, diluted FB (1 500 by volume), WV (1 800 by volume) applied as soil drench and foliar spray, in nine treatment combinations which included untreated control treatment.

However, if low application rates are used then the timing of application may be less important.

That skepticism may help explain the low application rates.

A water infiltration problem caused by low ECw or high SAR occurs primarily in the upper few centimetres of soil; therefore, the low application rates of gypsum to correct the surface problem are more effective if left on the soil surface or mixed with soil to a shallow depth rather than incorporated deeper into the soil as for reclamation.