Sentence examples for lowered adhesion from inspiring English sources

The lowered adhesion and friction force were attributed to two factors including (1) the reduced real area of contact between DLC films and colloidal tip; (2) incorporation of thin ILs films to avoid direct contact between DLC films and colloidal tip, which facilitating the sliding of colloidal tip on DLC films.

Also the exposure to PS caused a slight decrease in the autophosphorylation of FAK indicating for the deactivation of FAK and lowered adhesion to the extracellular matrix.

In capsulate bacteria, pilus interactions dominate, yet, in the presence of certain pilus structures with lowered adhesion capacity, Opa proteins also mediate adherence of capsulate meningococci to the meningioma cells [ 141].

All supplementations were effective in lowering adhesion molecules but in different extents VT1 lowered sICAM-1 significantly, T1 lowered sICAM-1 and sVCAM-1, while V lowered sICAM-1, sVCAM-1 and sE-selectin (Fig. 3a c).

However, the compressive and the flexural strength of the concrete both decreased due to lower adhesion between cement paste and waste glass.

The much higher hydrophicility of cPU resulted in the lowered cell adhesion (OD at day 1).

At the same time point (3 h post infection), the F4ac ETEC was the most adhesive strain, followed by F4ab ETEC with a little bit lower adhesion value (P > 0.05), whereas F18ac ETEC showed the lowest adhesion pattern compared to F4ac ETEC and F4ab ETEC (P = 0.078).

Lower height to length ratio results in lower adhesion requirement, while higher cross-sectional area also results in lower adhesion requirement.

Lower adhesion failure and DTS were observed at higher test temperatures.

The pseudoboehmite surface exhibited a lower adhesion performance, despite having the highest surface energy.

Compared to protein nanofibers, PCL nanofibers showed much lower adhesion, as they slipped on the substrate when mechanically manipulated.