Sentence examples for lower limit used from inspiring English sources

To exclude occasional prescribers (physicians without a practice but who can prescribe for themselves and relatives), prescribers with less than 200 prescriptions in 2008 were not included in the sample (100 prescriptions per semester is the lower limit used by the TPP to include a prescriber in the feedback on low-cost drugs).

Serum albumin levels were measured with the bromcresol purple method and employed as the biochemical marker of nutritional status: levels <3.5 mg/dL of albumin (hypoalbuminemia) were taken to indicate malnutrition; in addition, levels <3.8 mg/dL were considered for analysis, given that this is the lower limit used at the Institute.

However, the chromosomal sets remained sufficiently large and exceeded the lower limits used by other studies [ 54].

The upper and lower limits used in the NOE comparison were calculated as described in Materials and Methods.

In this context, our mapping population consisting of 232 advanced breeding forms of triticale was quite large and above the lower limits used by others.

With these SD, the upper and lower limits used in the one-way sensitivity analyses of wages were close to the 5th and 95th percentiles of the distributions in the probabilistic sensitivity analysis.

We summed x and n for 101 neighbouring SNPs (50 on each side of a focal site) and computed upper and lower limits (using binomial test described above), shown by blue and red lines in Figure 3A-D and Figure 4A-D.

The lower temperature limit used was 400°C, repeating the experiments with 100°C increments.

Competence is defined as the point where the downward slope crosses the lower control limit using an α and β error of 0.1.

This suggests that the logistic regression model was well calibrated when the p values of the KS tests were used as predictive variables (as in models 2 and 3) but not when only the stratified PRR and its lower limit were used as predictive variables (as in model 1).

Therefore, an upper limit and a lower limit were used to cover the entire range of material properties within each group.