Sentence examples for lower cut off frequency from inspiring English sources
The performance of conventional Tunnel FETs struggling from ambipolar issues, insufficient on-current, lower transconductance value, higher delay and lower cut off frequency has been improved by introducing several material and device engineering concepts in past few years.
As shown by model calculations by Fujita ([1987], [1988], the group velocity of Pc1 pulsations as a function of frequency increases near the lower cut off frequency.
The amplifier setting was 100 μV; the lower cut off frequency was 10 Hz and the upper cut off frequency was 100 Hz.
On the other hand, the lower cut-off frequency should be calculated using Skålevik's model as the value obtained from Rindel's formula is undervalued.
The design of a continuous-time high-pass filter with lower cut-off frequency as low as 20 Hz, which is suitable for realisation in a CMOS process, is presented.
Experiments demonstrate our proposed approach can dramatically boost the measured power of the energy harvester as much as 35 times while its lower cut-off frequency is two times lower than that of a conventional counterpart.
Kesselman, Spallation neutron source beam current monitor electronics, PAC2001 June 18 22 , 2001 Chicago, IL.] that extends the lower cut-off frequency of the current transformer, optimized for high frequency response, so that it can be used in this application with improvements in droop of the order of 1000 1.
Corner frequencies of a particular stage can be digitally controlled in a wide range, i.e. the upper cut-off frequency can be changed in the 20 Hz–2 kHz (LFP stage) while the lower cut-off frequency can be tuned at the 120 mHz–3 kHz (LFP and AP stage).
The bandpass filtering conditions have different bandwidths (lower cut-off frequency Hz, upper cut-off frequency Hz).
In addition to the weightings, we introduced a lower cut-off frequency of 100 Hz and an upper cut-off frequency of 5 kHz to stabilize the CSP analysis.
The spectrogram was produced at a frequency resolution of 488 Hz and a time resolution of 1 ms. A lower cut-off frequency of 20 kHz was used to reduce background noise outside the relevant frequency band.
