Sentence examples for lower concentration level from inspiring English sources

The absence of phase transition in hafnia can thus be explained by the lower concentration level attained by these defects, owing to their higher diffusivity in this material.

At the start of heat flow, if we increase the concentration, the average Nusselt number is always higher than its value at lower concentration level, but as the process moves toward the steady state, the average Nusselt number decreases after a fixed concentration level, and this concentration level depends upon the temperature of the plate.

The estrone in all samples was in the range of 0.1 15.7 ng·L−1, whereas β-estradiol was measured at a lower concentration level (0.1 2.3 ng·L−1).

Although transcriptional analysis of Clostridium beijerinckii exposed to furfural has been recently reported [ 16], the detrimental effect of aromatic compounds arouse from lignin portion is severer than other compounds from sugar, such as furfural, at lower concentration level [ 2].

To exclude the presence of unfavorable sorption of arsines in the NaOH dryer at 20 times lower concentration level, i.e., 100 ng L 1, the measured peak areas corresponding to individual arsines were compared with those measured without the NaOH dryer.

The gas-phase concentration of DEHP in the chamber was very sensitive to the chamber air flow rate, and higher air flow rates resulted in lower concentration levels.

The experiments in this study were performed at lower concentration levels, and the results obtained complied with or surpassed quality-control requirements specified in EPA 314.0.

A similar trend was observed for the standard drug, isoniazid (INH) which exhibited a dose dependent efficacy, though at a much lower concentration levels (Fig. 6).

The lower concentration levels of fluoride in the water samples of Denkada anicut indicate that the water is free from contamination by agricultural runoff.

This enhanced precipitation contributed to severe random arcing at the source tip, thereby rendering data (integrity) obtained at lower concentration levels to be compromised.

Moreover, the total power loss was dominated by grid shadowing effect at lower concentration levels; while at higher concentration levels the lowest total power loss condition was found when a compromise occurred mainly between grid shadowing effect and resistance of metal lines.