Sentence examples for low strength values from inspiring English sources

This very low strength values were due to both the total air content (in the matrix) and required mixing water (to achieve uniformity and consistency of fresh mortar mix) associated with the LWF incorporation which were exacerbated by the lower isostatic crush strength (2.07 MPa) of GMS15 particles.

Without this added acidic component, pure pectin produced low strength values.

As a consequence, at t=0, the strength distribution of these links is narrow and centred about a relatively low strength value (Supplementary Figure S2A).

It is also found that mortars with porous slag had the lowest strength values and the highest permeability.

The commercially available mortar Ref 1 showed the lowest strength value.

Cow gastric lysozyme is a basic enzyme adapted to act in the harsh gastric conditions, with optimal activity at low pH (4.5 5.2), low ionic strength values, and resistant to acid and pepsin [ 6, 7].

Regular bis-GMA resin cements which do not contain the MDP itself may show low bond strength values.

The percentage of sites assigned an ARI scores of score 0 for all groups, indicating a poor interaction of the tooth structure with the bonding systems [21], which can result in low shear strength values.

Despite the fact that current dental adhesive approaches vary in dentin bonding ability [119], low bond strength values may not be capable of overcoming the shrinkage stresses generated during the polymerization of the resin luting agent, as a thin layer of curing resin with limited free surface for stress relief creates an undesirable scenario when C-factor is a concern [120].

Also, Chen and Liu developed expanded polystyrene foam composite with density of 400 and 800 kg/m3 with excellent thermal insulation properties (lower thermal conductivity coefficient) but the extremely low corresponding strength values of 3 and 13 MPa hampered the use in structural applications (Chen and Liu 2013).

In our study, failure in n = 6 specimens of group 4, with low tensile strength values, was caused by the sutures cutting through the tendon without the suture material itself breaking.