Sentence examples for low creep from inspiring English sources
For highly demanding engineering applications, the adhesive should have multiphase, cross-linked materials that yield high modulus and fracture strength, low creep, and good performance at elevated temperatures.
Under such a test protocol, while the expected increase in strain during creep (constant tensile load) is observed, at relatively low creep stresses specimens have also demonstrated a monotonic decrease in strain.
In spite of the greatest historical Mg usage at present, the wider use of Mg alloys remains restricted by a number of inherent limitations, including vulnerability to corrosion, poor formability and low creep resistance.
A highly swellable, stretchable, low creep, non-cytotoxic nanocomposite hydrogel has been fabricated by simple one-pot Michael type covalent grafting of acrylic acid based copolymer onto psyllium biomacromolecular chian by free radical gelation technique.
The compressive creep test conducted at temperatures between 1150 and 1250 K showed the presence of threshold stress and also extremely low creep rates when compared with the conventional Ni-based superalloys with dispersed oxide particles.
Industry professionals and state transportation agencies are wary about incorporating high amounts of reclaimed asphalt pavements (RAP) into new mixtures owing to their high stiffness and low creep rate.
How to recognise it: Low, creeping plant with shamrock-shaped leaves and white flowers.
The Baltic Dry Index has recovered from its pitiful low, creeping back up to 3,345 on July 24th.
White clover, a low creeping perennial, is often used in lawn-grass mixtures and bears a white flower head often tinged with pink.
Dichondra, also called Lawn-leaf, any of several species of low, creeping plants of the morning glory family (Convolvulaceae) that are used in warm climates as grass substitutes.
However, the specimens heat-treated at 1050 °C exhibited the lowest creep resistance among all tested samples, with a surprisingly short rupture time of < 25 h, much shorter than the specimen coated at 1050 °C.
