Sentence examples for loss shrinkage from inspiring English sources

Tests were undertaken with a small oven within a test machine measuring mass loss, shrinkage, bending strength, and modulus of elasticity at elevated temperatures.

We consider an appropriate measure of discrepancy between estimated and true values of a to be the sum of squared errors (i.e., quadratic loss), l (a ^,   a ˜ ) = ∑ j = 1 j (a ^ j − a ˜ j ) 2. In decision problems involving the estimation of three or more effects under quadratic loss, shrinkage estimators typically dominate simple means (Parmigiani and Inoue 2009).

Several of the most prominent drawbacks of high temperature concreting include the increased water demand, slump loss, drying shrinkage, autogenous shrinkage, decreased mechanical and durability properties.

The system pickup efficiency, specific moisture extraction rate, dimensionless mass loss, mass shrinkage ratio and drying rate are discussed in this paper.

It was found that the introduction of electroplating sludge reduced the bulk density and compressive strength, and increased the mass loss, linear shrinkage, porosity ratio and water absorption.

It is shown by independent measurements that significant changes in pycnometric density, mass loss, and shrinkage all occur in the same temperature range (800 1200 K).

The objective of this study was to investigate the effect of heat treatment on physical and mechanical properties including oven-dry density, weight loss, swelling, shrinkage, and hardness of southern red oak (Quercus falcata Michx).

Sensory quality was evaluated and scored using a modified 5 (excellent quality) to 1 (poor quality) scale after Song et al. [1]: where 5, fresh without any water loss (no shrinkage on appearance); 4, slight green appearance and water loss; 3, moderate green appearance and several water loss; 2, severe green appearance and water loss; 1, entirely green appearance and water loss.

The influence of both the increasing incorporation of PUR foam waste and the presence of superplasticizer on the workability, bulk density, mass loss, drying shrinkage, compressive strength, dynamic modulus of elasticity, total porosity, gas permeability and chloride diffusion coefficient of the different concretes, has been investigated and analyzed.

A dose of 25 µg ASO caused α-motor neuron loss and shrinkage, by 2 months post-injection (Fig 4).

In general, the available neurochemical and neuropathological evidence from subjects with increased Mn concentrations in the brain suggests primary involvement of the globus pallidus, expressing the loss or shrinkage of neurons and glial cell activation.