Sentence examples for loss of parallel from inspiring English sources

Alternatively, Eph receptor-dependent signals that induce spine retraction and synapse loss [64] may be active in the dendritic regions surrounding active climbing fibre synapses, leading to loss of parallel fibre innervation.

We found that whereas single treatments with Noc or LatB caused a slight loss of parallel (0° 15°) spindles, a much greater loss of parallel orientation was seen with the double, Noc + LatB, treatment.

About 41% of the pk1a morphants displayed a complete loss of parallel organization of the two stratified tracks and were classified as severe (Fig. 4C′).

Live imaging of spindles in double-treated, Noc + LatB, embryos revealed that loss of parallel orientation resulted from "tumbling" of the spindles in and out of the plane of the epithelium.

Similarly, our results show loss of parallel organization in the proximal/central part of the wing but not distally (with some other signal presumably organizing the distal region, as discussed in this manuscript and below).

In addition, the evaluation of collagen fibers waviness showed an increase of entropy, suggesting not only an increase of collagen fibers deposition but also a loss of parallel fibrillar distribution, leading to a possible increase in the distribution network of collagen fibers and a consequent increase in the resistance of vascular wall, as recently reported [ 31].

This paper presents a consistent-degradation macroblock grouping scheme for improving loss resilience of parallel video streams over a two-class DiffServ network.

To ensure efficiency and fairness of multi-stream macroblock ordering, the compound transmission distortion is introduced to measure both worst-case and average-case loss resilience of parallel video streams.

The mean weight loss of all parallel steels was obtained, and then corrosion rates (W) and inhibition efficiency (%IE) were calculated [25].

Previously, it was demonstrated how a few nanofibers could be transferred by a drop-casting technique and connected electrically to metal contacts for electrical two-point measurements, but this method was very time-consuming, with a low yield, and with loss of the parallel alignment [25].

The reference point for measurement of the IMT was the beginning of the dilatation of the carotid bulb, with loss of the parallel configuration of the near and far walls of the common carotid artery.