Sentence examples for located measurement from inspiring English sources

The time lag observed between symmetrically located measurement points which are equidistant from the point of excitation, is utilized to predict the mass flow rate.

Results indicated that twelve randomly located measurement points are enough to characterize site-specific LAI with standard error less than 0.15 LAI units.

Site-means of UHI intensity are compared; case studies are carried out on strategically located measurement points; and regression analysis is followed to examine the significance of the on-site design variables in relation to UHI intensity.

In view of a practical realization of the proposed observer approach, the idealized system output, previously assumed as measurable on the entire boundary hyperplane, is reconstructed from a limited set of optimally located measurements by means of a least squares approximation.

Unfortunately, we were not able to locate measurements of linear growth in rodents that might provide more sharply defined points of comparison for the data in Figure 6.

This feature is beneficial, for example, for more accurate identification of soil contamination zones where high contamination measurements are located near measurements of varying contamination.

In Figure 5 it is possible to observe that the Side-2-Side ratio obtained from the symmetrically located BIS measurements on healthy measurements is close to 1.

We located 13 measurements of BaP-emissions or concentrations in eight different U.S. tunnels between 1961 and 2004.

Curnow et al were not able to accurately ascertain in which tissue layer the polarographic Eppendorf needle is located during measurements.

In order to observe any differences between healthy and damaged brains, two straightforward approaches have been used:   1st is Side-2-Side ratio: the ratio between symmetrically located BIS measurements has been calculated for the resistance spectrum, that is, one ratio has been obtained for the left and right lateral measurements and one for the left and right central measurements.

1st is Side-2-Side ratio: the ratio between symmetrically located BIS measurements has been calculated for the resistance spectrum, that is, one ratio has been obtained for the left and right lateral measurements and one for the left and right central measurements.