Sentence examples for loaded tube from inspiring English sources

A load adapted design of complex reinforcement structures was developed for compression and bending loaded tube samples, using numerical simulation of the deformation behavior.

The inter fibre fracture surface of the investigated CFRP materials was determined with tension torsion loaded tube specimens of 90°-laminate and a layer-wise strength analysis was done.

This paper describes a numerical study of the stress distribution in a pin-loaded tube, loaded in tension, where more than one pin is used.

Using BSA-encapsulated microspheres as the model drug delivery system, BSA was released from microsphere loaded tubes (MLTs) for 84 days, and from freely suspended PLGA microspheres for 70 days.

After 2 weeks of implantation 3 out of 5 of the loaded tubes showed bone formation with a mean of 0.3 mm2 areas of new formed bone, after 8 weeks 3 out of 6 and 0.7 mm2, and after 12 weeks this increased to 6 out of 6 and 1.0 mm2.

Loaded tubes tubes were held for 40 min in a preheated air-circulation oven, at different set temperatures.

The loaded tubes were centrifuged at 300 g for 20 min. ●  Colloidal centrifugation Protocol 2: 5 ml of raw semen (i.e., without extender) were placed over 5 ml of Bottom Layer® EquiPure® following the same instructions as in Protocol 1. ● After centrifugation, the supernatant (semen extender, seminal plasma and colloid) was removed by aspiration.

The genomic DNA that we had pre-loaded in the plasma tube was recovered and visible as a high-molecular weight band co-migrating with purified genomic DNA, while no corresponding band was visible in the serum isolated from the pre-loaded tube.

In the non-loaded tubes only connective tissue in growth was seen.

Blood was then collected into the pre-loaded tubes, and plasma or serum was separated.

On the other hand, the indirectly loaded UHPFRC tube had a limited influence, but the structural integrity of the UHPFRC tube appeared to affect the restraining of bar-buckling, which could result in a reduction of the energy dissipation.