Ai Feedback
Exact(13)
Increasing the liner compression also increased peak flow rates, with an increasing effect at greater vacuum.
The primary objective of this study was to quantify and compare the interactive effects of liner compression, milking vacuum level, and pulsation settings on average milk flow rates for liners representing the range of liner compression of commercial liners.
Increasing liner compression reduces the effects of teat-end congestion, resulting in increased MFR and increased CA at high levels of teat-end vacuum and milk-phase time.
Ten liners, representing a wide range of liner compression (as indicated by overpressure), were assessed, with treatments applied using a novel quarter-milking device.
A high correlation between OP and liner compression estimated by the ATS was found, but difficulties were noted when using the ATS with triangular liners.
During the d-phase of the pulsation cycle, liner compression facilitates venous flow and removal of fluids accumulated in teat-end tissues.
Similar(47)
This is a hemispheric porous-coated (titanium mesh) cup with a polyethylene liner (compression-molded GUR 1050; Ticona, Summit, NJ) sterilized with γ-irradiation in nitrogen.
The Monoblock cup is a non-modular system, where the polyethylene liner is compression molded directly into the metal shell.
The cup is a non-modular system where the 10° liner is compression molded directly into the metal shell.
As exhibited in Fig. 9a, the current almost displays a liner response to compression deformation from 0 to 12 mm and back to 0 mm; meanwhile, it holds a fast response and a good stability to the ascending and descending pressures, besides, there only exists a little deviation between a continuous ascending and descending test.
Because TBC on the top piston surface decreases the thermal conductivity and increases the unburned charge oxidation by increasing the temperature in the flame quenching area near the entrance of the crevice volume between the piston and liner during the compression and the early part of the expansion strokes.
Write better and faster with AI suggestions while staying true to your unique style.
Since I tried Ludwig back in 2017, I have been constantly using it in both editing and translation. Ever since, I suggest it to my translators at ProSciEditing.

Justyna Jupowicz-Kozak
CEO of Professional Science Editing for Scientists @ prosciediting.com