Sentence examples for limits of tensile from inspiring English sources

For example, if SWNTs can be made in bundles of 100 billion, then a material will be produced that may approach the limits of tensile strength possible for any known material involving the chemical bond.

The limits of tensile strength, elongation at break, hardness, tear strength, fluid compatibility, compression set and specific gravity defined for the Viton GBL 200S/600S based inflatable seal formulation provide a standardized framework for regular production of reactor seals and a streamlined approach for compounding, design, manufacture and quality control.

The glass breaks when it reaches limit of tensile stress and the projectile passes through the glass (Saferstein 2006; Nabar 2008).

For both CuCrZr-IG and CuAl25-IG alloys, the statistical evaluation of available experimental data has been used to calculate the temperature dependence of the average value and of the 95% confidence limit of tensile properties.

All specimens (n = 8) of the double-row groups (group 1 and 2) exceeded the defined limit of tensile strength of 250 N, whereas this limit was not achieved in n = 8 specimens of group 4 and in n = 6 specimens of the group 3 (P < 0.001).

JUST as a balloon filled gradually with air bursts when the limit of its tensile strength is passed, there are thresholds of radical, disruptive change in politics.

b Upper limit of maximum tensile and compressive strains.

a Lower limit of maximum tensile and compressive strains.

The decrease of limit tensile stress with the porosity, the coloring and the sealing combined to thermal stresses due to the difference of thermal expansion coefficients between film and substrate have been shown to cause crazing in particular conditions.

It turns out that the tensile force detected in the experiment is much less than the upper limit of material's tensile strength, which means that the geotextile may not be easily damaged just by the tensile stress caused by waves.

For a coating on the non-preheated base the calculated strain stresses considerably exceed in both layers the limit of the SF6 tensile strength, whereas in the case with preheating to 600 °C the calculated values lie below that limit.