Sentence examples for limited stiffness from inspiring English sources

Hence, the ladder has a limited stiffness and will be more and more subject to oscillations of deflection along with dominant overtones.

The limited stiffness of the micro-end mills is a big impediment in machining difficult-to-cut materials, such as hardened steels and Ti-alloys.

A decrease in joint stiffness of approximately 8% was observed for the tensile and reversed loading conditions, while a very limited stiffness degradation of around 2% was recorded under compression.

Consequently, high spindle speeds and low chip loads in a tool with limited stiffness can lead to chatter induced dynamic instability which deteriorates the part quality, surface finish and tool life.

Despite drawbacks of the DRR method (i.e., sensitivity to noise and limited stiffness range), its results predicted a similar cyclic stiffness variation to that offered by velocimetry while being insensitive to variations in applied radiation force.

We note here that it is difficult to achieve the conjugated polymer nanostructure by room temperature NIL method using PDMS as imprinting mold directly, since the PDMS material is not only provided with limited stiffness but also easy to absorb the organic solvent and change into swell or deform, leading to be incapable of obtaining uniform nanostructure precisely.

However, a full study of the effect of lateral braces on inelastic buckling has not been made especially for castellated beams, and it is not known whether the limiting stiffness for elastic buckling can be applied to castellated beams that buckle inelastically.

All the polyacrylate binders showed a similar rheological profile with a unique viscoelastic response as represented by the phase angle master curves together with an upper limiting stiffness and intermediate temperature/frequency 'plateau' region as shown in the complex modulus master curves.

Experimentally, pulse repetition frequency during displacement tracking limits stiffness resolution using the time to peak displacement parameter.

Note that the spring force can be nonlinear so as to incorporate coupler slack, preload and limiting stiffness [11].

The final model must also consider coupler slack as well as the limiting stiffness that appears after springs are fully compressed.